100% Original 10 Pin RJ45 Jack - 10021246-218LF Modular Jack Ethernet Connector Without LED 2×8 Port RJ45 – Zhusun

Product Detail

10021246-218LF Modular Jack Ethernet Connector Without LED 2x8 Port RJ45

Categories	Connectors, Interconnects
Categories	Modular Connectors - Jacks
Application-LAN	ETHERNET(NoN POE)
Connector Type	RJ45
Number of Positions/Contacts	8p8c
Number of Ports	2x8
Applications Speed	RJ45 Without Magnetics
Mounting Type	Through Hole
Orientation	90° Angle (Right)
Termination	Solder
Height Above Board	27.31 mm
LED Color	Without LED
Shielding	Shielded
Features	Board Guide
Tab Direction	UP & Down
Contact Material	Phosphor Bronze
Packaging	Tray
Operating Temperature	-40°C ~ 85°C
Contact Material Plating Thickness	Gold 6.00µin/15.00µin/30.00µin/50.00µin
Shield Material	Brass
Housing Material	Thermoplastic
RoHS Compliant	YES-RoHS-5 WIth Lead in Solder Exemption

Connector function application: electric power application Generally used are the following two power transmission methods: dedicated to high-level simultaneous power contact transmission and parallel polygonal signal contact. Each of them has advantages and disadvantages. There are two differences between power transmission and signal transmission. It is also obvious that it is used to deliver higher currents. The current transmitted by the signal generally does not exceed 1 ampere, and does not exceed a few amperes in many cases, and the current transmitted by the power can reach tens or even hundreds of amperes. The point is the increase in temperature due to Joule heating caused by the current. The Joule heat generated during the signal contact process is similar to the surrounding temperature. On the contrary, the ratio of power transmission is based on the increase in temperature, and the increase in temperature generates a corresponding ratio current. A temperature increase of 30 degrees is generally used as a current ratio specification. Therefore, in order to satisfy the current rating and the stability requirements of the function, it is necessary to control the Joule heat. This requires consideration of the signal transmission in the planning and the power transmission as well. Especially for terminals with large resistance, Joule heat is a primary factor, and it is necessary to reduce it to a low level, and the resistance of the contact surface must also be reduced to a low level to minimize the amount of heat generated. From the perspective of material selection, of course, select terminals with high conductivity or larger cross-sectional area to reduce resistance. In addition, increasing the transmission voltage or increasing the contact area can also reduce the resistance of some contacts.

Product Tags

10 Pin RJ45 Modular Jack