Home Categories Send inquiry

Wholesale 48 Pin LAN Transformers - H5PNX 10/100BASE-T Five PORT 72PIN DIP LAN Transformer Network Filter – Zhusun

The RJ connector manufacturing process can be divided into four stages: 1 stamping 2 electroplating 3 injection molding 4 assembly.

Plating

After the connector pin is stamped, it should be sent to the electroplating section. At this stage, the electrical contact surface of the connector will be plated with various metal coatings.

The RJ connector manufacturing process can be divided into four stages: 1 stamping 2 electroplating 3 injection molding 4 assembly.

Injection

The plastic box seat of the electronic connector is made in the injection molding stage. The usual process is to inject the molten plastic into the metal fetal film, and then quickly cool it to form. So-called short shots occur when the molten plastic fails to completely fill the fetal membrane; (Short Shots), which is a typical defect that needs to be detected during the injection molding stage. Other defects include filling or partial blockage of the sockets (the sockets must be kept clean and unobstructed so that they can be correctly connected to the pins during the final assembly).

H5PNX 10/100BASE-T Five PORT 72PIN DIP LAN Transformer Network Filter

Categories  Transformers
 Network Transforme
Transformer Type  ETHERNET(NoN POE)
PIN Contacts  72
Number of Ports  Five Port
Mounting Type  DIP
Turns Ratio - Primary:Secondary  1CT:1CT
Packaging  Tube
Operating Temperature  -40°C ~ 85°C
Comment  SAME AS NL VERSION
Construction  OPEN FRAME
RoHS Compliant  YES-RoHS-5 WIth Lead in Solder Exemption

 

The cable needs to be terminated with similar connection equipment. For example, the connectors of category 5e and category 6 are similar in appearance, but are different in physical organization. If a Category 5e cable is terminated with a Category 3 connector or distribution panel, the function of the cable channel will be reduced to Category 3. Therefore, in order to ensure the functional indicators of the cable, it is necessary for the module connector to reach the corresponding specifications.
Network transmission lines are divided into straight-through lines, interspersed lines and full-reverse lines. Straight-through cables are used to interconnect different types of network devices. For example, a computer and a switch plug-in cable is used to interconnect the same type of network devices, for example, a computer and a computer. The all-reverse line is used for the connection between the hyper terminal and the physical interface of the network device.