100% Original 10 Pin RJ45 Jack - ARJ11F-MASA-A-B-EM2 With LED Gigabit Ethernet 12 PIN Lengthen RJ45 Female Connector Jack – Zhusun

Product Detail

ARJ11F-MASA-A-B-EM2 With LED Gigabit Ethernet 12 PIN Lengthen RJ45 Female Connector Jack

Categories	Connectors, Interconnects
Categories	Modular Connectors - Jacks With Magnetics
Application-LAN	ETHERNET(NoN POE)
Connector Type	RJ45
Number of Positions/Contacts	8p12c
Number of Ports	1x1
Applications Speed	100/1000 Base-T, AutoMDIX
Mounting Type	Through Hole
Orientation	90° Angle (Right)
Termination	Solder
Height Above Board	0.537" (13.65mm)
LED Color	With LED
Shielding	Shielded, EMI Finger
Features	Board Guide
Tab Direction	UP
Contact Material	Phosphor Bronze
Packaging	Tray
Operating Temperature	-40°C ~ 85°C
Contact Material Plating Thickness	Gold 6.00µin/15.00µin/30.00µin/50.00µin
Shield Material	Brass
Housing Material	Thermoplastic
RoHS Compliant	YES-RoHS-5 WIth Lead in Solder Exemption

The analysis method of the RJ connector is basically the same as the usual signal analysis method, which is to use simulation software to simulate, analyze the results, and draw conclusions. The model analysis of the RJ connector is the same as the model analysis of the circuit. Just pay attention to the accurate modeling and simulation of RJ and the via effect, which is very important for guessing the signal quality. The following are five models of RJ connector model analysis: 1. The single wire model is suitable for single wires in RJ, such as high-speed signal transmission lines, which can be used to simulate reflection, delay and offset, attenuation, and signal transmission quality. 2. The S-parameter model is mainly used in the frequency domain, which can simulate throughput and crosstalk. After time domain transformation, impedance, crosstalk, transmission delay and eye diagrams can be generated. 3. The multi-wire model is suitable for multi-pin RJ, including touch components, coupling between touch and touch, coupling between touch and shielding, coupling between pads, etc. In addition to the parameters imitated by SLM, it can also be used to imitate crosstalk and ground bounce. 4. The IBIS model is a fast and accurate modeling method for I/O BUFFER based on the V/I curve. It supports all types of RJ and a variety of different RJ modeling, such as differential and unbalanced signaling, SLM (without Coupling), MLM (coupling), model cascading, board-to-board and board-to-cable, etc. 5. SPICE model: It is a ubiquitous circuit-level simulation program. The components in the analyzed circuit can include resistance, capacitance, inductance, mutual inductance, independent voltage source, independent current source, various linear controlled sources, transmission lines, and active semiconductors. Device.

Product Tags

6 Pin RJ45